公司新聞

裝載機發動機啟動后及作業時的安全事項

來源：http://m.id888.com.cn/ 日期：2023-02-20

①裝載機發動機啟動后，等制動氣壓達到安全氣壓時再準備起步，以確保行車時的制動安全性。有緊急制動的把緊急及停車制動閥的按鈕按下（只有當氣壓達到允許起步氣壓時，按鈕才能按下，否則按下去會自動跳起來），使緊急及停車制動釋放下，才能掛I擋起步。無緊急制動的只需將停車制動手柄放下，釋入停車制動即可起步。

① After the loader engine is started, prepare to start when the brake air pressure reaches the safe air pressure to ensure the brake safety during driving. If there is emergency braking, press the button of the emergency and parking brake valve (only when the air pressure reaches the allowable starting air pressure, the button can be pressed, otherwise it will jump up automatically), so that the emergency and parking brake can be released, and then I gear can be engaged to start. If there is no emergency brake, just put down the parking brake handle and release the parking brake to start.

②清除裝載機在行走道路上的故障物，特別要注意鐵塊、溝渠之類的障礙物，以免割破輪胎。

② Clear the fault objects on the road of the loader. Pay special attention to the obstacles such as iron blocks and ditches to avoid cutting the tires.

③將后視鏡調整好，使駕駛員入座后能有很好的視野效果。

③ Adjust the rearview mirror so that the driver can have a good visual effect after sitting.
濟南裝載機租賃

④濟南裝載機租賃廠家提醒，確保裝載機的喇叭、后退信號燈，以及所有的保險裝置能正常工作。

④ Jinan loader rental manufacturer reminds us to ensure that the horn, back signal light and all safety devices of the loader can work normally.

⑤裝載機租賃在即將起步或在檢查轉向左右靈活到位時，應先按喇叭，以警告周圍人員注意安全。

⑤ When the loader leasing is about to start or when checking the flexibility of turning left and right, the horn should be sounded first to warn the surrounding personnel to pay attention to safety.

⑥在起步行走前，應對所有的操縱手柄、踏板、方向盤先試一次，確定已處于正常狀態才能開始進入作業。要特別注意檢查轉向、制動是否完好。確定轉向、制動完全正常，方可起步運行。

⑥ Before starting and walking, all the joysticks, pedals and steering wheels should be tested first, and the operation can only be started after confirming that they are in normal state. Pay special attention to check whether the steering and braking are in good condition. Make sure that the steering and braking are completely normal before starting.

⑦行進時，將鏟斗置于離地400mm左右高度。在山區坡道作業或跨越溝渠等障礙時，應減速、小轉角，要注意避免傾翻。當裝載面在陡坡上開始滑向一邊時，必須立即卸載，防止繼續滑下

⑦ When traveling, place the bucket at a height of about 400mm from the ground. When working on slopes in mountainous areas or crossing ditches and other obstacles, slow down and turn small corners, and pay attention to avoid tipping. When the loading surface starts to slide to one side on a steep slope, it must be unloaded immediately to prevent it from continuing to slide down

⑧裝載機作業時盡量避免輪胎過多、過分打滑；盡量避免兩輪懸空，不允許只有兩輪著地而繼續作業。

⑧ Try to avoid too many tires and excessive skidding during the operation of the loader; Try to avoid two rounds of suspension, and it is not allowed to continue operation with only two rounds of landing.

⑨作牽引車時，只允許與牽引裝置掛接，被牽引物與裝載機之間不允許站人，且要保持一定的安全距離，防止出現安全事故。

⑨ When being used as a tractor, it is only allowed to connect with the traction device. No person is allowed to stand between the towed object and the loader, and a certain safety distance should be kept to prevent safety accidents.

其實這些裝載機租賃操作規程都是平常駕駛員應該做到的小細節，很容易達到要求，多留心，多注意就行了。關注我們http://m.id888.com.cn，了解更多事項！

In fact, these operating procedures for loader leasing are small details that ordinary drivers should do. It is easy to meet the requirements. Just pay more attention and pay more attention. Follow us http://m.id888.com.cn , learn more!

上一條：市政工程道路瀝青砼面層的施工事項

下一條：裝載機的安裝調試與組成的注意事項